Transport Safety; Assembly - Husqvarna P 535HX Manual De Usuario

speed is too high, the product
components can become
damaged. Refer to
data on page 64 for highest
permitted engine speed.
• The product is approved only
with the equipment supplied
or recommended by the
manufacturer.

Transport safety

• Use an approved transport
vehicle for transportation of
the product.
• A markets national or local
regulations can set limit to the
transportation of the product.
To attach the cutting deck - Combi 155,
R180
Note:
Make sure that the cutting deck and the product
are on level ground before you attach the cutting deck.
1. Put the lever for the hydraulic lift arms to the position
(B) to lower the lift arms.
C
B
A
WARNING:
the hydraulic lift arms to the float position
(A). The force from the lift spring can
cause injury.
26
Technical

Assembly

D
Do not put the lever for
• The operator of the transport
vehicle is responsible to
attach the product safely
during transport. Refer to
safely attach the product on a
trailer for transport on page
61 .
Note: To move the product with
the power off, the automatic
parking brake must be
disengaged. Refer to
product on page 62 .
2. Carefully move the product into position in front of
the cutting deck.
3. Put the lift arms into the joint of the cutting deck.
4. Apply the parking brake.
5. Turn the power key to the STOP position.
6. Install the bolts (A) and attach the pins (B) on the lift
arms.
To
To tow the
1591 - 001 - 21.12.2020