General Information; Product Description - Enerpac BP1 Serie Instrucciones

3.4 Dimensions
C
Pump Model
A
BP122 9.62
BP122E [24,43]
BP124 12.18
BP124E [30,93]
Note: All dimensions are approximate. Reservoir mounting holes (item F) are 1/2 inch diameter, non-threaded.

4.0 GENERAL INFORMATION

4.1 Product Description

The Enerpac BP1 Series pump is designed for use in places
where access to AC line power is inconvenient or unavailable. It
consists of an 0.4 hp [0,29 kW] DC motor, 28 volt rechargeable
Li-Ion battery pack, two-stage hydraulic pump, and manual
three-way, two-position control valve. The pump is available with
a 2 or 4 liter hydraulic reservoir.
D
F
B
Dimensions in inches [cm]
B C
12.15 16.16
[30,86] [41,04]
14.50 16.25
[36,83] [41,28]
4
G
E
D E
4.06 5.25
[10,31] [13,33]
4.15 6.56
[10,54] [16,66]
4.2 Legal Information – Pump Components And
Subassemblies
The battery pack, charger and DC motor assembly ("powerhead")
used on the Enerpac BP1 Series pump are manufactured
by Milwaukee Electric Tool Corporation. "Sawzall
"V ™ -technology" and the Milwaukee Electric Tool logo are
trademarks and intellectual property of Milwaukee Electric Tool
Corporation.
The capitalized and italicized "MILWAUKEE" text used in
various places throughout this document denotes products
and/or components manufactured by Milwaukee Electric Tool
Corporation.
Product support for the Enerpac BP1 Series pump is available
only through Authorized Enerpac Service Centers. Refer to
Section 9.5 of this document for additional information.
A
F G
8.12 4.61
[20,62] [11,70]
12.77 4.70
[32,44] [11,94]
®
", "V28 ™ ",