Troubleshooting Chart - Enerpac BP1 Serie Instrucciones

9. Fill reservoir with new Enerpac hydraulic oil. Note: Use only
Enerpac hydraulic oil. Use of any other oils or fl uids may
damage pump or seals and will void the pump warranty.
10. Remove air from the system. Refer to Section 6.5.
9.4 Cleaning the Powerhead
Clean out dust and debris from vents and electrical contacts by
blowing with compressed air.
Keep the powerhead dry and free of oil or grease. Use only mild
soap and a damp cloth to clean the powerhead, keeping away
from all electrical contacts.
Never use a power washer to clean or rinse the powerhead.
Certain cleaning agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline, turpentine,
lacquer thinner, paint thinner, chlorinated cleaning solvents,
ammonia and household detergents containing ammonia. Never
use fl ammable or combustible solvents around the pump.
9.5 Repairs
For factory authorized repair service, take the pump, charger and
battery pack to the nearest Authorized Enerpac Service Center. It
is important to include all three items, so that your Service Center
representative can make an accurate diagnosis of the problem.
10.0 TROUBLESHOOTING
The Troubleshooting Chart is intended as a guide to help you diagnose and correct various possible problems.
Only qualifi ed hydraulic technicians should troubleshoot and service the pump. For repair service, contact the Authorized Enerpac
Service Center in your area.
Note: For detailed battery and charger information, refer to the separate battery and charger instruction sheet provided with your
pump.
Problem
1. Pump will not start
2. Pump slows down and stops.
3. Pump clicks when trigger is
depressed, but does not start.

Troubleshooting Chart

Possible Cause
Battery pack not installed.
Electrical contacts dirty or corroded.
Battery pack discharged.
Battery pack shut-off.
Motor damaged.
Battery pack discharged.
Electrical contacts dirty or corroded.
Battery pack discharged.
Battery too cool or too warm.
Battery pack damaged or not functioning.
Pump jammed due to obstruction. Possible
internal damage to pump.
IMPORTANT: Milwaukee Electric Tool Corporation and its
authorized service centers and retailers do NOT provide product
support or warranty service for components used on Enerpac
products.
The MILWAUKEE Sawzall
serviceable internal parts. It must be replaced as a complete
unit if worn-out or damaged. A replacement powerhead, custom
engineered for the BP1 Series pump, is available from your
Authorized Enerpac Service Center.
The MILWAUKEE Li-Ion charger and the MILWAUKEE V28
Ion battery pack contain no serviceable internal parts. Replace
these items if they are damaged, non-functional or have reached
the end of their useful life. For additional information, refer to the
separate battery and charger instruction sheet included with your
pump.
CAUTION: To prevent possible personal injury, do not
attempt to lubricate, disassemble, modify or repair the
powerhead, charger or battery pack.
The pump control valve and pump element assembly contain
various serviceable components. However, repairs must be
performed only by qualifi ed and trained hydraulic technicians.
Action
Install battery pack.
Clean the electrical contacts on the battery,
pump and charger.
Charge battery.
Refer to separate battery and charger
instruction sheet for additional information.
Have pump inspected and repaired by
Authorized Enerpac Service Center.
Charge battery.
Clean the electrical contacts on battery and
pump.
Charge battery.
Battery will shut off if it is cold or overheated.
If necessary, allow time for battery to reach
operating temperature.
Replace battery pack.
Have pump inspected and repaired by
Authorized Enerpac Service Center.
9
®
based powerhead contains no
™ Li-