Sauder Palladia 411836 Instrucciones De Montaje página 14

9 9
N
Fasten the TOP MOLDINGS (M and N) to the ENDS (A and B). Tighten four TWIST-LOCK
Fasten the BOTTOM (D) to the ENDS (A and B). Tighten four TWIST-LOCK
Page 14
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain
fully inserted in the hole of the adjoining part while
locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver
as tight as possible.
Dowel end
M
These holes
must be here.
B
www.sauder.com/services
®
FASTENER
A
D
Surface with
TWIST-LOCK® FASTENERS
® FASTENERS.
®
FASTENERS.
411836