Sauder Palladia 411836 Instrucciones De Montaje página 17

12 12
YY
NAIL
(34 used in this step)
Carefully turn your unit over onto its front edges. Unfold the BACK (E) and lay it over your unit.
Make equal margins along all four edges of the BACK (E). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (E) to your unit using the NAILS (YY).
Fasten two TIE PLATES (EE) to the PLINTHS (R2) and BASE (G). Use four BLACK 9/16" LARGE HEAD SCREWS (VV).
411836
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
E
Printed information
must be facing up.
www.sauder.com/services
G
R2
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
R2
EE
VV
Page 17