Control Panel; Status Led; Input And Output Connector - Legamaster STX-5810 Manual Del Usuario

4.4. CONTROL PANEL

Key
Power
Source
►
◄
▲
▼
Menu/Exit

4.6. INPUT AND OUTPUT CONNECTOR

1 2 3
Touch USB 1
A standard, Type B USB port for the touch functionality of the
1
display. To be used in combination with the DisplayPort and
HDMI video input sources.
Touch USB 2
A standard, Type B USB port for the touch functionality of the
2
display. To be used in combination with the VGA and DVI video
input sources.
RS232C In
3 A female, 9-pin D-sub connector for interfacing with a PC or
home theatre automation/control system.
LAN Port
4 An RJ-45 connector for interfacing with a PC or AV automation/
control system via a Cat 5 cable.
DisplayPort
DisplayPort 1.1a and DisplayPort-HDCP 1.1 compliant, SD/HD
5
input for connecting SDTV, EDTV or HDTV component video
sources.
HDMI
6 HDCP-compliant digital video input for connecting HDMI or DVI
sources.
Descriptions
Power on/Power off
Source selection (toggle)
Menu Right/Volume +
Menu Left/Volume -
Menu Up
Menu Down
Menu/Exit selection
4 5 6 7
INSTALLATION

4.5. STATUS LED

LED Illumination Condition
Green Normal operation
Blinking Orange No signal
Orange Power Saving
Power off
Off
AC off
Note:
If the Status LED is set to „Off" in the OSD
menu, the Status LED will not operate.
8 9 10 11
DVI-D In (HDCP-compliant)
7 HDCP-compliant digital video input for connecting HDMI or DVI
sources
VGA In (15-pin D-Sub)
Connects components that have RGB or component output
8
jacks, such as a personal computer or external DTV decoder (a
break-out cable is needed for BNC-type connection).
Audio Out
9 Connects external, powered speakers or an external audio
receiver/ amplifier.
IR Extender
10 Connects the IR Extender cable provided with the display to this
input.
PC Audio In
11
Connects the audio output from a personal computer here.
Power (100 to 240 VAC)
12
Connects the display to power here.
STX-5810/STX-6510 – USER MANUAL – ENGLISH
12
11