Touch Screen Configuration - Legamaster STX-5810 Manual Del Usuario

7.3. TOUCH SCREEN CONFIGURATION

Click the icon on the bottom right corner as shown
below:
Switch Button
A row of switch buttons on top of the screen can be used
to switch between different settings.
Select the switch icon, and click Apply to switch.
The maximum touch points of the frame; bright steady
Device switch; bright for on, grey for off
HID switch; bright for on, grey for off
Mouse switch; bright for on, grey for off
TUIO switch; bright for on, grey for off
Flash switch; bright for on, grey for off
Palm recognition; bright for on, grey for off
Calibration: if touching the screen does not place
the cursor in the desired position, you may be able
to correct this by performing a touch screen engine
calibration.
1. Click calibration
2. During calibration, vertically press and hold each
Click to
spinning target until it stops spinnning, then
start the
turn to the next spinning target.
driver
application
No calibration is needed if the resolution ratio
under Windows 10 is not the same as the screen. If
you would like to calibrate, please use the built-in
calibration tool of Windows under: [Control Panel]
> [Tablet PC settings] > [Calibrate].
Click to show
hidden icons
When you switch the Device/HID/Mouse button to
closed, you'll be warned that the touch function of
the device will be disabled. Make sure the mouse
and keyboard are securely connected to the PC to
ensure continuous control to the device.
TOUCH OPERATION
STX-5810/STX-6510 – USER MANUAL – ENGLISH
21