Advanced Settings Menu - Legamaster STX-5810 Manual Del Usuario

OSD (ON-SCREEN DISPLAY) CONTROLS

6.2.4. Advanced Settings Menu

Auto Adjustment
Force the display to reacquire and lock to the input
signal (VGA source only). This is useful when the
signal quality is marginal.
Options: No, Yes
Default: No
Note: This feature does not continually reacquire the signal.
Image Position
Press ◄ or ► to shift the projected image
horizontally.
Press ▲ or ▼ o shift the projected image vertically.
Phase
Adjust the phase of the displayed signal (VGA
source only).
Press ◄ or ► to select the desired level, and then
press ENTER.
Range: 0~63
Clock
Adjust the frequency of the pixel sampling clock of
the displayed signal (VGA source only).
Press ◄ or ► to select the desired level, and then
press ENTER.
Range: 0~100
Default: 50
IRFM
Create slight frame motion to help avoid image
retention
Options: On, Off
Default: Off
Baud Rate
Select the baud rate of the display's RS232 port
Options: 115200, 38400, 19200, 9600
Default: 115200
18
STX-5810/STX-6510 – USER MANUAL – ENGLISH
Smart Light Control
Enable dynamic contrast (DCR) or ambient light sensor
Options: Off, DCR, Light Sensor
Default: Off
Wake Up from Sleep
Options: VGA Only, VGA/Digital/RS232; Never Sleep
Default: VGA Only
Ethernet Setup
Press ► to configure the display's network settings.
Factory Reset
Restore all settings to their default settings.
Options: No, Yes
Default: No
Wake Up from Sleep
By default, the display will enter power saving (Sleep
Mode) if no signal is received for 5 minutes. Normally,
the RS-232, DisplayPort, and HDMI inputs are inactive in
Sleep Mode, to save power.
To change the behavior of Sleep Mode, change the
"Wake up from Sleep" setting in the "Adv. Setup"
menu.
I. VGA Only (default)
The display normally wakes up from power-saving
mode when it receives an active video signal on its
VGA (analog) input.
II. VGA, Digital, RS232
The RS-232, DisplayPort and HDMI inputs stay active
when the display is in sleep mode. The display wakes
up when it receives an active signal from its VGA,
HDMI, DisplayPort or DVI inputs, or receives a valid
RS-232 command.