Legamaster STX-5810 Manual Del Usuario página 19

Ethernet Setup
Enable Network
Enable the display's built-in Ethernet port
Options: No, Yes
Default: No
IP Address Settings
Enable Dynamic IP mode or set the static IP address of
the display's Ethernet port
(See default network settings in next page)
Power Status Alert
Enable an automatic alert when the display is powered
down
Options: No, Yes
Default: No
Source Status Alert
Enable an automatic alert when the source is changed
Options: No, Yes
Default: No
OSD (ON-SCREEN DISPLAY) CONTROLS
Signal Lost Alert
Enable an automatic alert when the video signal is
lost
Options: No, Yes
Default: No
Load Default
Load default network settings
Options: No, Yes
Default: No
IP Address Settings
To assign an IP address to your display, use the
default settings shown below, or consult your
system administrator if you do not know how to
configure the parameters.
Item
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
DNS ADDRESS
System Settings Menu
This read-only menu provides information on the
active sources and the latest firmware version
Setting
Disabled
192.168.2.1
255.255.255.0
192.168.2.1
192.168.2.1
STX-5810/STX-6510 – USER MANUAL – ENGLISH
19