Operations; Turning The Display On And Off; Adjusting The Volume And Input Source; Osd (On-Screen Display) Controls - Legamaster STX-5810 Manual Del Usuario

OPERATIONS / OSD (ON-SCREEN DISPLAY) CONTROLS

5. OPERATIONS

5.1. TURNING THE DISPLAY ON AND
OFF
Turning the display on
1. Connect the display to an AC power outlet
2. Ensure the AC switch is set to "—".
3. Press the power button on the remote control or
keypad.
Turning the display off
With the power on, press the power button on the
remote control or keypad to put the display into standby
mode. To turn off power completely, turn the AC switch
to "O" or disconnect the AC power cord from the
power outlet.
Note:
If there is no signal input for a period of time, the
display will automatically go into power saving (sleep)
mode.

6. OSD (ON-SCREEN DISPLAY) CONTROLS

To display the on-screen menus, press MENU on the remote control or built-in keypad.
To select a sub-menu, use the ▲ and ▼ buttons to highlight it. Then, press ► to enter that sub-menu.
To select a menu item, use the ▲ and ▼ buttons to highlight it. Then, press ◄ or ► to adjust that setting and
press ENTER.
The OSD menus are arranged hierarchically, as shown in the following table. Depending on the selected input
source and signal characteristics, some menu options may not be available.
5.2. ADJUSTING THE VOLUME AND
INPUT SOURCE
Adjusting the Volume
1. Using the remote, press the VOLUME- or
VOLUME+ to increase or decrease the volume.
2. Press the MUTE button to temporarily turn off
all sound. To restore the sound, press the MUTE
button again.
Selecting the input source
1. Using the remote, press the desired source
button (DISPLAYPORT, HDMI, VGA, DVI)
2. Or press SOURCE on the display keypad, use
the arrow buttons (▲▼) to navigate to the
desired input source, and press ENTER:
• DisplayPort
• VGA
• HDMI
• DVI
3. If the display cannot find a source, a "No
signal" message will appear.
STX-5810/STX-6510 – USER MANUAL – ENGLISH
13