Fuses: Replacing - IPC CT80 Manual De Instrucciones

Fuses: replacing

This operation must be performed with the machine switched off and the key removed.
Never use a fuse with a higher amperage than specified.
Do not rest the electronic board panel on the batteries, as a short-circuit may cause the bat-
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be identified
and repaired. Have the machine checked by qualified personnel.
Lift the dirty water tank, disconnect the battery wiring connector from the electrical system (fig. 20,
ref. 1-2-3), lift the electronic board panel, secure it to the corner of the tank, as shown in the figure
(fig. 21), then check the fuses.
20
1
2
3
! DANGER!
! WARNING!
! DANGER!
teries to explode.
21
GB 30