Stihl HS 46 Manual De Instrucciones página 11

pesticide or herbicide), read and follow
the instructions and warnings that
accompanied the substance at issue.
WARNING
Inhalation of certain dusts, especially
organic dusts such as mold or pollen,
can cause susceptible persons to have
an allergic or asthmatic reaction.
Substantial or repeated inhalation of
dust and other airborne contaminants, in
particular those with a smaller particle
size, may cause respiratory or other
illnesses. Control dust at the source
where possible. Use good work
practices, such as operating the unit so
that the wind or operating process
directs any dust raised by the power tool
away from the operator. Follow the
recommendations of
EPA/OSHA/NIOSH and occupational
and trade associations with respect to
dust ("particulate matter".) When the
inhalation of dust cannot be
substantially controlled, i.e., kept at or
near the ambient (background) level, the
operator and any bystanders should
wear a respirator approved by
NIOSH/MSHA for the type of dust
encountered.
Operating Instructions
WARNING
Do not operate your power tool using the
starting throttle lock, as you do not have
control of the engine speed.
In the event of impending danger or in
an emergency, switch off the engine
immediately – move the Master Control
lever in the direction of STOP or †.
HS 46, HS 46 C, HS 56 C
WARNING
The cutting blades continue to move for
a short period after the throttle trigger is
released (flywheel effect.)
Accelerating the engine while the blades
are blocked increases the load and will
cause the clutch to slip continuously.
This may result in overheating and
damage to important components (e.g.
clutch, polymer housing components) –
which can then increase the risk of injury
from the blades moving while the engine
is idling.
WARNING
Before you start work, examine the
hedge area for stones, fence wire, metal
or other solid objects which could
damage the cutting blades.
Take particular care when cutting
hedges next to or against wire fences.
Do not touch the wire with the cutting
blades. When working close to the
ground, make sure that no sand, grit or
stones get between the cutting blades.
Striking solid foreign objects such as
stones, fence wire or metal could
damage the cutting attachment and may
cause the blades to crack, chip or break.
STIHL does not recommend the use of
your power tool when cutting in areas
where the blades could contact such
objects.
WARNING
Observe the cutting blades at all times –
do not cut any areas of the hedge that
you cannot see. When cutting the top of
a taller hedge, check the other side of
the hedge frequently for bystanders,
animals and obstructions. Do not
damage the property or other persons.
DANGER
Your power tool is not
insulated against electric
shock. To reduce the risk
of electrocution, never
operate this power tool in
the vicinity of any wires or
cables (power, etc.)
which may be carrying
electric current.
WARNING
If the cutting blades becomes clogged or
stuck, always turn off the engine and
make sure the cutting blades has
stopped before cleaning. Grass, weeds,
etc. should be cleaned off the cutting
blades at regular intervals.
Check the cutting blades at regular short
intervals during operation, or
immediately if there is a noticeable
change in cutting behavior:
Shut off the engine.
–
Wait until the cutting blades have
–
come to a complete standstill.
Check condition and tightness, look
–
for cracks.
Check sharpness.
–
Replace damaged or dull cutting
–
blades immediately, even if they
have only superficial cracks.
English
9