Lubricating The Gearbox - Stihl HS 46 Manual De Instrucciones

3
WARNING
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press the spark plug
boot (1) firmly and securely onto the
spark plug terminal (2).
Do not use a spark plug with a
detachable SAE adapter terminal (3).
Arcing may occur that could ignite
combustible fumes and cause a fire.
This can result in serious injuries or
damage to property.
Only use resistor type spark plugs
N
with solid, non-threaded terminals
HS 46, HS 46 C, HS 56 C
Installing the Spark Plug
Insert and screw home the spark
N
plug by hand.
1
Tighten down the spark plug.
N
Press the spark plug boot firmly
N
onto the spark plug.
2
Close the flap (1), top first, then the
N
bottom, tabs (arrows) must snap
into position.

Lubricating the Gearbox

Commercial usage only – check every
25 hours of operation
HS 46
Use STIHL gear lubricant for hedge
trimmers (special accessory) to lubricate
the blade drive gear.
2
Remove the screws (1) from the
N
underside of the unit.
Remove the retaining plate (2) and
N
gearbox cover (3).
6
4
Squeeze grease into the gearbox
N
housing (arrow) between the
cam (4) and cutting blade (5) a little
at a time (max. 5 g (1/5 oz)) while
turning the drive pinion (6) with a
English
1
1
3
1
1
5
21