Downloading Further Instructions - Balluff BTL7-P511-M Serie Instrucciones Breves

BTL7-P511 -M _ _ _ _ -P-S32/KA_ _
Micropulse Transducer in a Profile Housing
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL7 Micropulse Transducer, together with a machine
controller (e. g. PLC), comprises a position measuring
system. It is intended to be installed into a machine or
system. Flawless function in accordance with the
specifications in the technical data is ensured only when
using original BALLUFF accessories. Use of any other
components will void the warranty.
Opening the transducer or non-approved use are not
permitted and will result in the loss of warranty and liability
claims against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists with basic electrical knowledge.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the position measuring system will not result in
hazards to persons or equipment.
If defects and unresolvable faults occur in the transducer,
it should be taken out of service and secured against
unauthorized use.

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
BTL7...-S32
1)
12 72
Groove
~80
BTL7...-cable
Mounting clamps with insulating bushes
~23
and ISO 4762 M5x22 cylinder-head screws,
max. tightening torque 2 Nm
max. 7
1 english
Nominal length =
Measuring range
2)
~250 ~250
Dimensions and function
The transducer contains the waveguide which is protected
by an aluminum housing. A magnet is moved along the
waveguide. This magnet is connected to the system part
whose position is to be determined. The magnet defines
the position to be measured on the waveguide.
LED 1
Normal function
Green
Magnet is within the limits.
Red Error
No magnet or magnet outside the limits.
LED 2
Off Normal function
Valid Init signal.
Init error
Flashing red
Missing or invalid Init signal and LED 1 is off.
Installation
NOTICE
Improper installation
Improper installation can compromise the function of the
transducer and result in damage.
► For this reason, ensure that no strong electrical or
magnetic fields are present in the immediate vicinity
of the transducer.
► The recommended spacing for the installation must
be strictly observed.
Any orientation is permitted. Mount the transducer on a
level surface of the machine using the provided mounting
clamps and cylinder-head screws. A sufficient number of
mounting clamps is supplied.
1)
73
~80
15
1) Unusable area
2) Not included in scope of delivery
File no.
E227256
2)
Magnet
BTL5-P-3800-2
LED 1 LED 2
35
50
68