Downloading Further Instructions - Balluff BTL6-U110-M-PF-S4 Serie Instrucciones Breves

BTL6-U110-M _ _ _ _ -PF-S4
Magnetostrictive Linear Position Sensor – Profile Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The magnetostrictive linear position sensor BTL, together
with a machine controller (e.g. PLC) and an IO-Link master,
comprises a position measuring system. It is intended to
be installed into a machine or system and used in the
industrial sector. Flawless function in accordance with the
specifications in the technical data is ensured only when
using original Balluff accessories. Use of any other
components will void the warranty.
Opening the BTL or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the BTL will not result
in hazards to persons or equipment.
If defects and unresolvable faults occur in the BTL, take it
out of service and secure against unauthorized use.

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
Output signal rising:
Error signal
100 %
0 %
Null point
1)
13 73
~80
1 english
End point
Nominal length =
Measuring range
2)
~250 ~250
Mounting clamps with insulating bushes
and ISO 4762 M5x25 cylinder-head screws,
max. tightening torque 2 Nm
Dimensions and function
The BTL contains the waveguide which is protected by an
aluminum housing. A magnet is moved along the
waveguide. This magnet is connected to the system part
whose position is to be determined.
The magnet defines the position to be measured on the
waveguide.
In normal operation the LED indicates the
operating states of the BTL.
LED Operating state
Green Normal function without IO-Link
communication
Magnet is within the limits.
Green Normal function with IO-Link
communication
flashing
inversely Magnet is within the limits.
Red Error
No magnet or magnet outside the limits.
Installation
NOTICE!
Improper installation
Improper installation can compromise the function of the
BTL and result in damage.
► For this reason, ensure that no strong electrical or
magnetic fields are present in the immediate vicinity
of the BTL.
► The recommended spacing for the installation must
be strictly observed.
Any orientation is permitted. Mount the BTL on a level
surface of the machine using the provided mounting
clamps and cylinder-head screws. A sufficient number of
mounting clamps is supplied.
1) Unusable area
2) Not included in scope of
1)
73
~80
15
UL approval
File No.
E227256
delivery
2)
BTL5-P-3800-2 magnet
34.8
50
LED
68