Functions And Operations; Specifications - Tunturi Cardio Fit Bike B40 Manual Del Usuario

+ 0,5KM
4Th goal to be set is; ODO
cannot change
5th goal to be set is: CAL
+ 1
6th Limit to be set is: PULSE
+ 1
NOTE:
• When you set a goals the set goal
value will count down in active mode.
• When goal is reached the console
will notify by 4 dual acoustic beep
signals. The reached value will now
count up starting from "0".
• You can set more than one goal,
all goals will notify when goal is
reached.
• When you set a limit for pulse, the
console will notify by a continues
triple acoustic beep signal when
exceed the set limit.
RESET
• Push and hold for 4 seconds to reset:
TIME, DISTANCE, CALORIES and
PULSE.
NOTE:
ODOMETER can only be reset by a
batteries exchange.

FUNCTIONS AND OPERATIONS

SCAN
Automatically scan functions for : TIME,
SPEED, DISTANCE, ODOMETER,
CALORIES and
PULSE.
Each display will be hold 4 seconds
TIME
Automatically accumulates workout time
when exercising.
SPEED
Display current speed when exercising.
DISTANCE
Automatically accumulates the distance
from exercise when exercising.
14
( 0,5KM ~ 99,50KM )
( max. 999,9 KM)
( 1 ~ 999 )
( 40 ~ 240 )
CALORIE
Automatically accumulates calories burnt
when exercising.
ODOMETER
Automatically accumulates the Total
distance for all exercise sessions.
PULSE RATE
Display current heart rate if measured.
Before measuring your pulse rate,
please place your palms of your hands
on both of your contact pads and the
monitor will show your current heart beat
rate in beats per minute(BPM) on the
LCD after 6~7 seconds.
Remark: During the process of pulse
measurement, because of the contact
jamming, the measurement value may
be higher than the virtual pulse rate
during the first 2~3 seconds, then will
return to normal level. The measurement
value cannot be regarded as the basis of
medical treatment.
NOTE:
• If the display is faint or shows no
figures, please replace the batteries.
• The monitor will automatically shut
in standby mode if there is no signal
received after 4 minutes.
• The monitor will be auto-powered on
when starting to exercise or at the
push of a button.
• The monitor will automatically start
calculating when you start to exercise
and will stop calculating when you
stop exercising for 4 seconds.

SPECIFICATIONS:

Function
• Auto scan Every 4 seconds
• Time 0:00 ~ 99:59
• Current speed The maximum
speed to be displayed is 99,9 KM/H
• Trip Distance 0.00 ~ 99.99 KM
• Calories 0.0 ~ 999.9 K.Cal
• ODO 0.1 ~ 999.9 KM
• Pulse rate 40 ~ 240 BPM