Shaking The Primary Filter; Emergency Stopping; Emptying The Dust Container; Tilting Discharge Device Replacement And Use - Nilfisk T30S Manual De Instrucciones

T30S

Shaking the primary filter

1 Main filter operating knob
Depending on the quantity of dust cleaned up, shake the main
filter by means of the knob (1).
Stop the vacuum cleaner before shaking the filter.
Do not shake the filter while the vacuum cleaner is on,
as this could damage the filter itself.

Emergency stopping

Press or turn the main switch to "0" position.

Emptying the dust container

Before proceeding with these operations, turn off the
vacuum cleaner and remove the plug from the power
socket.
Before emptying the container it is advisable to clean the filter
(see "Shaking the filter" paragraph).
1 Dust container
■ Release the container (1), then remove and empty it.
■ Make sure that the seal is in perfect condition and
correctly positioned.
■ Place the container back in position and secure it again.
GB
C341
Figure 7
WARNING!
WARNING!
Figure 8
Tilting discharge device replacement and
use
1 Tilting discharge device assembly
■ Fasten the hopper to the filtering chamber, by inserting it
into the relevant housings and, operating on the lever (2)
to lock it (figure 9).
■ Insert the bag (Longopac
fasten its end with the belt (1, figure 10).
■ Engage the tilting discharge device support to the hopper
by fastening it with the relevant pins (figure 9).
■ Remove the bag (Longopac
support platform and close its end with the supplied
clamp.
■ When the bag is full (Longopac
end with two clamps by fastening them at 50 mm one
from the other, then with a pair of scissors cut the bag
between the two clamps (figure 10).

Single plastic bag replacement and use

Place the plastic bag outside the tilting discharge device
support, taking care that the bag bottom lays on the lower
support platform and lock the upper part of the bag with the
belt.
8
Figure 9
) into the relevant support and
®
) until it lays on the lower
®
) close the upper
®
Figure 11
01/2015