Makita LS1214 Manual De Instrucciones página 22

When adjusting the laser line appears on the right
side of the saw blade
1
1. Screw to change the
movable range of the
adjusting screw
3. Laser line
For both adjustments, do as follows.
1. Make sure that the tool is unplugged.
2. Draw the cutting line on the workpiece and place it
on the turn table. At this time, do not secure the
workpiece with a vise or similar securing device.
3. Lower the blade by lowering the handle and just
check to see where the cutting line and the position
of the saw blade is. (Decide which position to cut on
the line of cut.)
4. After decision the position to be cut, return the han-
dle to the original position. Secure the workpiece
with the vertical vise without shifting the workpiece
from the pre-checked position.
5. Plug the tool and turn on the laser switch.
6. Adjust the position of laser line as follows.
The position of laser line can be changed as the movable
range of the adjusting screw for the laser is changed by
turning two screws with a hex wrench. (The movable
range of laser line is factory adjusted within 1 mm (0.04")
from the side surface of blade.)
To shift the laser line movable range further away from
the side surface of blade, turn the two screws counter-
clockwise after loosening the adjusting screw. Turn these
two screws clockwise to shift it closer to the side surface
of the blade after loosening the adjusting screw.
Refer to the section titled "Laser line action" and adjust
the adjusting screw so that the cutting line on your work-
piece is aligned with the laser line.
NOTE:
• Check the position of laser line regularly for
accuracy.
• Have the tool repaired by Makita authorized service
center for any failure on the laser unit.
006344
2
2. Saw blade
Cleaning of the lens for the laser light
For model LS1214L only
3
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the
lens for the laser light carefully with a damp, soft cloth.
Do not use solvents or any petroleum-based cleaners on
the lens.
To remove the lens for the laser light, remove the saw
blade before removing the lens according to the instruc-
tions in the section titled "Installing or removing saw
blade".
Loosen but do not remove the screw which secures the
lens using a screwdriver.
Pull out the lens as shown in the figure.
NOTE:
• If the lens does not come out, loosen the screw
further and pull out the lens again without removing
the screw.
Replacing fluorescent tube
For LS1214F only
1
3
1. Pull out
3. Lamp box
5. Fluorescent tube
22
006346
1. Screwdriver
1
2. Screw (one
3. Lens for the
2
3
006347
1. Lens for the
1
2
1
4
5
2. Push
4. Screws
piece only)
laser light
laser light
002028