Tabla de contenido
Publicidad
OPERATION SWITCHES WHEN
EMBROIDERY UNIT IS ATTACHED
OPERATION SWITCHES
START/STOP SWITCH
When start/stop switch is pushed, machine starts slowly, and
when the switch is pushed once more, the needle moves and
stops at its highest position.
FORWARD STITCH SWITCH
Embroidering can be advanced one stitch at a time (The hoop
moves.), after the embroidery data has been transferred.
To advance continuously, press and hold this switch.
REVERSE STITCH BUTTON
Embroidering can be reversed one stitch at a time (The hoop
moves.), after the embroidery data has been transferred.
To reverse continuously, press and hold this switch.
Embroidering can be reversed until the start of the embroidery
data, after which it will no longer move.
LED INDICATOR
Green light indicates machine is ready to start.
Red light indicates machine is operating.
Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect
operation was made.
* Continuous flashing indicates that machine malfunctions.
THREAD TENSION CONTROL
Set it at "E" for embroidery to loosen thread tension.
You may wish to re-adjust thread tension according to the type
of fabric and thread being used.
NOTE: When sewing designs created by the software for
Photo Stitch (optional) it is recommended to decrease the
thread tension toward "0" and activate the "Speed limiter",
by checking the box in Machine navigator, before sending
the design to the machine. This will give a more stable
stitching condition.
86
Forward stitch switch
Interupteur couture avancé
Interruptor de puntadas
hacia adelante
Reverse stitch switch
Interrupteur couture arrière
Interruptor de puntadas
hacia atrás
LED indicator
Témoin a diode
Start/stop switch
Indicador LED
(For embroidery only)
Interrupteur marche/arrêt
(Pour la broderie seulement)
Pulsador de comienzo/parada
(Sólo para bordado)
Publicidad
Tabla de contenido
