‼ NOTE
•
Do not over tighten any component with
pivoting function.
•
Make sure all pivoting components are able
to move freely.
Operation notes
Weight Plate Selection
- Use the Weight Selector Pin to select the
number of weight plates to exercise.
- Do not insert weight selector pin while the
weight stack or top plate is in elevated position.
- Be certain the weight Selector Pin is completely
inserted.
- Each Weight Plate weights approximately 7 kgs.
- Please refer to Weight Resistance Chart page.
- Never use dumbbells or other means to
increase the weight resistance. Use only weight
plates provided by manufacturer.
- For safety purpose while the equipment is
not in use. Insert the Lock Pin into the hole on
Guide Rod, to prevent the movement of Weight
Plates.
Cable Tension Adjustment
Do not tighten all Nuts
and Bolts in this step.
Adjust the tension of
the Cable System by
moving the position of
lower Pulley on the two
Double Floating Pulley
Brackets.
If the tension is too
loose, move the lower
pulley up by one hole.
If the tension is too
tight, move the lower
pulley down by one
hole
Weight resistance chart
1
100
14,0
2
109
23,0
3
118
32,0
4
127
41,0
5
136
50,0
6
145
59,0
7
154
68,0
8
163
77,0
9
172
86,0
10
181
95,0
‼ NOTE
•
Each plate weights 7 kgs. ( 15 Lbs ).
•
Numbers are approximate.
•
Actual weights may vary.
•
Values for Butterfly are for each arm.
Values are shown in kgs
Use
Arm Curl Pad Adjustment
(Fig. Use #5)
Pull up and flip the Arm Curl Pad along the track
on the Arm Curl Stand to face toward back when
doing Leg Press exercises.
Do not over tighten Allen Bolt (#93) so the Bolt
can move along the track smoothly.
Adjusting the backrest
(Fig. Use #6)
- Pull the adjustment knob.
- Move the backrest to the required position.
- Release the adjustment knob.
English
4,5
11,0
14,0
9,0
18,0
23,0
13,5
30,0
32,0
17,0
36,0
41,0
21,5
44,0
50,0
26,0
50,0
59,0
30,5
59,0
68,0
35,0
68,0
77,0
39,5
77,0
86,0
45,0
86,0
95,0
21