Apex GM320T SD TENS Manual De Usuario página 17

TROUBLESHOOTING
If.the.device.does.not.function.properly:
1.. Make. sure. the. battery. is. properly. installed,. or. replace. the. battery.. Be. sure. to. observe. proper.
polarity.markings.when.replacing.the.battery..If.the.low-battery.indicator.appears.when.the.unit.is.
turned.on,.replace.the.battery.and.check.again.
2.. If. the. intensity. has. been. adjusted. and. there. is. no. stimulation,. check. that. the. lead. wires. are.
properly.connected.and.the.electrodes.are.in.place..If.the.unit.appears.to.be.functioning.and.no.
stimulation.occur,.the.lead.wires.or.electrodes.may.need.to.be.replaced.
3.. If.the.battery.appears.to.be.charged.and.the.unit.is.not.functioning, turn both intensity Control
Knobs to the OFF position (counter clockwise) for about 7 sec.. Then. gradually. turn. the.
intensity.Control.Knob.clockwise.until.stimulation.is.felt..If.device.still.is.not.working,.turn.the.unit.
off.and.contact.your.distributor.
If any other problems occur, please consult or return the device to your distributor.
Don't try to repair a defective device.
DIGI STIM_3 languages .indd 15
15
English
2013/2/23 AM 09:12:15