Labels And Markings - 3M Delta 1100373 Manual Del Usuario

7.0 RFID TAG
7.1 LOCATION: 3M product covered in these user instructions is equipped with a Radio Frequency Identification (RFID) Tag.
RFID Tags may be used in coordination with an RFID Tag Scanner for recording product inspection results. See Figure 16
for where your RFID Tag is located.
7.2 DISPOSAL: Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For more information, please visit our website: http://www.3M.com/FallProtection/RFID
8.0

LABELS and MARKINGS

8.1 LABELS: Figure 18 illustrates product labels and their location on the Full Body Harness. All labeling must be present and
fully legible. Information on each label is as follows:
1 Size label.
ANSI Warning label: Warning: Manufacturer's instructions must be read and understood prior to use. Instructions
supplied with this product at time of shipment must be followed. Failure to do so could result in serious injury or death.
Contact Capital Safety if instruction sheet is needed. Inspect before each use. Do not use if wear or damage is present.
This body harness is intended to be used to arrest the most severe free falls. Items subjected to fall arrest or impact
forces must be immediately removed from service and destroyed. Connecting snap and D-ring must be compatible
2
in size, shape and strength. This item is not flame or heat resistant. Repairs only to be performed by Capital Safety.
Equipment modification or misuse voids warranty.
Do not exceed capacity of this or other system components. Capacity is the combined weight for which the component is
designed to be used. Combined weight includes the user's body weight, clothing, tools, and any objects carried. Contact
Capital Safety for more information.
Fall Protection Application label: A) Dorsal attachment element is for fall arrest, travel restraint, or rescue. B) Sternal
3
attachment element is for fall arrest (feet first falls only, 2 ft. maximum free fall), travel restraint, or rescue. C) Frontal
attachment element is for fall arrest (feet first falls only, 2 ft. maximum free fall), work positioning, travel restraint, or
rescue. D) Shoulder attachment elements are for rescue or entry/retrieval. E) Waist, rear attachment element is for
travel restraint. F) Hip attachment elements are for work positioning or travel restraint.
Compliance label: ANSI Z359 Recognizes the use of this harness only within the capacity range of: 130-310 lb.
4
This product complies with the following standards only if marked with the corresponding letter code under the "Stds"
section.
Inspection log.
5
26