Accessories - Husqvarna 543 XP Manual Del Usuario

Saw chain speed at 133% of maxi-
mum engine power speed, ft/s / m/s.
Recommended cutting equipment
A specific chainsaw model has to be evaluated with the
cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw models Husqvarna 543 XP, 543 XPG met the
safety requirements in ANSI B175.1-2012 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
Guide bar
Length, in/cm Pitch, in
13/33 0.325
15/38
16/41
18/46
13/33 0.325
15/38
16/41
18/46
13/33 0.325
15/38
16/41
18/46
Pixel
Pixel is a guide bar and saw chain combination that is
more light weight and designated to offer more energy
956 - 004 - 11.10.2019
Husqvarna 543 XP
80.7/24.6

Accessories

Gauge, in/mm Max. nose ra-
dius
0.050/1.3 10T
0.050/1.3 10T
0.058/1.5 10T
Husqvarna 543 XPG
80.7/24.6
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Saw chain
Type
Husqvarna
H30
Husqvarna
SP33G
Husqvarna
H25
Length, drive Low kickback
links (no.)
56 Yes
64
66
72
56
64
66
72
56 Yes
64
66
72
35