Contact Grinding (Figure 6); Face Grinding (Figure 7); Suction Device (Figure 2) - Fein GRIT GI1502H5V6 Manual Del Usuario

GI 75 (US).book Seite 14 Dienstag, 4. November 2008 10:39 10
en

9.6 Contact grinding (Figure 6).

The workpiece must always lie
WARNING
securely on the grinding rest and
the stop. Workpieces that are too small or too thin
may not be worked. Danger of injury from work-
pieces pulled into the machine.
Check if the star-knob bolt is firmly tight-
ened.
Ensure that the top protective cover is
secured with star-knob bolt and that the
side cover is shut.
Check the gap size of the grinding rest.
Check the position of the face-grinding rest.
The adjustment screws must be in the bot-
tom position.
Check if the screws of spark guard are properly
tightened.
Switch the machine on and check the belt
run.
Place the workpiece firmly onto the grinding
rest.
Guide the workpiece with both hands or
fasten it in a fixture.

9.7 Face grinding (Figure 7).

Hold the workpiece with both
WARNING
hands. The workpiece must
always lie securely on the face grinding rest and
the stop. Workpieces that are too small or too thin
may not be worked. Danger of injury from work-
pieces being pulled in or thrown from the
machine.
Loosen the star-knob bolts and remove the
top protective cover.
Make sure that the gap size is correctly
adjusted. (Figure 7)
Switch the machine on and check the belt
run.
Guide the workpiece with both hands and
remove it to upward after the working pro-
cedure. (Figure 7)

9.8 Suction device (Figure 2)

The machine can be connected via the
sleeve to a dust extraction system.
14
GI 75
Fig. 6
WARNING
Fig. 7
WARNING