Instructions Of Use - GYS Inductor Lite Manual De Instrucciones

INSTRUCTIONS OF USE

No-Load : when no metal piece to heat is detected, or if the inductor is used with a non-ferrous metal, the indicator «
no-load » switches ON.
Manual mode : in this mode, the user manually selects the heating power, from the minimum to the maximum heating
power. To enter in this mode, press the MODE key until the LED in front of « MANUAL » lights up. The digital display
shows the percentage of the maximum heating power (2400W) that the inductor can transfer to the piece of metal. The
heating power will be higher if the inductor is brought closer to the piece of metal. Beware: at maximum power, heating
a metal parts can be very fast !
Automatic mode : in this mode, the product automatically adjusts the heating power depending on the inductor used,
the piece of metal to heat, and the distance between the inductor and the piece of metal, in order to maintain a constant
heating. The device always transfers the same heating power independently of the distance between the inductor and
the piece of metal to heat. To enter in this mode, press the MODE key until the LED in front of « AUTO » lights up. This
mode is particularly recommended for glass removal. In this mode, the heating power is limited to the « OK » zone on
the front panel, and the product does not heat at maximum power. The digital display shows the latest value in % used
by the product in order to maintain a constant heating power transferred to the piece of metal. This value corresponds
to the setting which could be used in Manual mode to get the same heating results, in the exact same conditions. Such
that if the user needs a bit more, or a bit less, heating power as compared to the Automatic mode, he knows which
setting to use in Manual mode and then he can slightly adjust the heating power.
Alarm BEEP when heating : an alarm BEEP can be activated in order to hear the heating activity of the product. If
this BEEP is activated, the frequency of the BEEPs will increase when the inductor is brought closer to the piece of metal,
and when the heating is effective. Press the MODE key for 3 seconds in order to activate this BEEP and/or disable it.
Thermal protection : this LED switches ON when the product enters thermal protection, following overheating inside
the product, in order to protect the components of the product. The product stops as long as this LED stays ON. Leave
the product cooling down until this LED switches OFF, in order to start heating again.
DESCRIPTION OF INDUCTORS
Fast-Off Attachment :
Inductor
®
Lite
1 Digital display
2 Adjustment keys
3 Thermal protection
4 Mode selection key
5 Power heating indicator
6 Selected mode
EN
13