Error Codes - GYS Inductor Lite Manual De Instrucciones

to release at the lowest possible temperature. See illustrations and notes on the next pages for additional information.
13. Typical removal time for small quarter glass is around 10 to 15 minutes. Typical removal time for rear glass and SUV
side glass is around 10 to 20 minutes. Front Glass can be removed in as little at 15 minutes, but some larger vehicles
require up to an hour to remove front glass.
Inductor consumables :
The bolt and glass inductors are covered with a fiber glass cloth protection, in order to apply them directly against the
parts to be heated. This cloth protection is a consumable which will wear and damage with use. These can be replaced,
and JBDC sells kits to allow users to perform this replacement.
053847 SET OF 10 BOLT INDUCTOR PROTECTIONS + GLUE
053854 SET OF 5 GLASS INDUCTOR PROTECTIONS + GLUE

ERROR CODES

CODE MEANING
E - 1 Pneumatic foot-pedal activated when the device is switched ON.
E - 2 Glass Blaster button switch activated when the device is switched ON.
E - 3 One key is activated on the front panel when the device is switched ON.
E - 4 Over-intensity in the inductor (either because it is too hot, or because there is a short circuit).
E - 5 Defective inductor (cut wire or disconnected wire).
NO– ACC Accessory not connected.
AC - Accessory not recognized.
16
®
Inductor Lite EN