Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Fueling
Before fueling, clean the filler cap and
the area around it to ensure that no dirt
falls into the tank.
Always thoroughly shake the mixture in
the canister before fueling your
machine.
In order to reduce the risk of burns
or other personal injury from
escaping gas vapor and fumes,
remove the fuel filler cap carefully
so as to allow any pressure build-up
in the tank to release slowly.
After fueling, tighten fuel cap as
securely as possible by hand.
FS 55
Fitting the Harness
The type and style of harness depend on
the market.
Shoulder strap*
:
Put on the shoulder strap (1).
:
Adjust length until the spring hook
(2) is about a hand's width below
your right hip.
:
Balance the brushcutter.
The use of the shoulder strap is
described in chapter "Approved
Combinations of Cutting Tool, Deflector,
Handle and Harness".
English / USA
Full harness
:
Put on the full harness (1).
:
Adjust length until the spring hook
(2) is about a hand's width below
your right hip.
:
Balance the brushcutter.
The use of the harness is described in
chapter "Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness".
27
Publicidad
Capítulos
Tabla de contenido
