Mounting The Bike Handle; Fitting The Handlebar - Stihl FS 55 Serie Manual De Instrucciones

English / USA

Mounting the Bike Handle

7
6
4
2
3
1

Fitting the handlebar

: Place the clamp (1) and handle
support (2) on the drive tube (3).
: Position the handlebar (4) in the
handle support – the rubber grip (5)
must be on the left (viewed from
engine).
: Place clamp (6) on handle support.
: Insert screws (7) in the holes and
screw down as far as stop in clamp.
18
5
: Secure handlebar (4) on the drive
tube (3) at distance (A) of approx.
15 cm (6 in) from the powerhead.
: Align the handlebar.
: Tighten down the screws firmly.
A
4
3
11
10
8
9
4
Fitting the control handle
: Release the screw (8) and remove it
with the washer. The nut (9) remains
in the control handle (10).
: Push the control handle onto the
handlebar (4) – the throttle trigger
(11) must point towards the
gearhead.
: Line up the holes (12).
: Fit screw and washer in control
handle and tighten down firmly.
* see "Guide to Using this Manual"
12
12
FS 55