lamber DSP1 Manual De Instrucciones página 19

- Put the dishes into the baskets after having
3
carefully removed any solid and fat waste. Leave
cutlery to soak previously and dishes too, if
necessary, in case they are going to be washed
long after having been used. Do not overload
baskets, dishes do not have to be placed one on
another, water must be able to cover any side of
the dishes.
In order to place dishes properly, see the special
paragraph.
WASHING
- Put the basket into the machine.
4
Close the door and push the button "B".
(NB: as regards DSP5 model, the cycle starts
when the hood is closed).
The lamp "F" stays ON without blinking and it
indicates that the cycle has begun.
The cycle will start for 2 minutes, including,
besides the washing, a five seconds stop and the
rinsing of 18 seconds (23 seconds for machines
with Water softener) with clean water at 85°C will
start.
Once the cycle has ended, the lamp "F" restarts
blinking.
- At the end of the cycle open the door and
5
pull out the basket.
The lamp "E" ON indicates that the washing
water and the rinsink water have reached the
ideal working temperature.
NOTE. STOP CYCLE function: the washing cycle can
be stopped if you push again the cycle pushbutton "B"
(light "F" flashing now) :
to restarting washing cycl push again button "B".
WARNING!
door during the washing cycle.
In case of accidental opening the cycle stops. If You
close the door, the cycle starts again from the point
where it had stopped.
At the end of the cycle open the door and pull out the
basket.
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. Any
halos might be caused by an insufficent rinsing:
in this case, check that the rinsing jets are clean
and there is a sufficient pressure in the water
distribution network.
In the case that residuals are present, check
that:
Do not open the dishwasher
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are
correct.
DISHES POSITIONING
It is suitable to place dishes, inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into the
suitable container minding not to cram them and
whit handgrips towards the bottom (see draw).
It is suitable to place glasses, inside the plastic
basket with the concave side towards the
bottom. Place mixed cutlery in a vertical position
into the suitable container minding not to cram
them and with hafts towards the bottom (see
draw).
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3 Afterwards push button "B" for 3 seconds.
(the lamp "H" is lighted).
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
(see also the paragraph "Day maintenance" ).
19