Working With The Tool; Maintenance And Care - Festool ETS 125 EQ Manual De Instrucciones

In this case, the extraction pipe (Ø 27 mm)
(4.1) of the extraction unit is connected to
the suction nozzle.
Attaching sanding
material
Stickfi x is a hook-and-loop fastening
system. Stickfi x sanding pads allow
the use of self-adhesive hook-and-loop
abrasives such as Stickfi x sandpapers
and sanding cloths.
5.2
Simply press the abrasive (5.1) onto the
sanding base (5.2) and pull it off again after
use.
Please note: Use only abrasives with an
undamaged Stickfi x hook-and-loop coating.
Before use, check that the coating has not
been damaged by improper use (such as over-
heating).
Always use original Festool
sanding materials!

Working with the tool

Always secure the workpiece
in such a manner that it cannot move while
being sanded.
Never overload the tool by
using too much pressure! The best sanding
results are achieved when applying moderate
pressure.
The sanding performance and quality depend
mainly on the choice of the right sanding
material. Festool offers the appropriate
sanding material for all applications (see
Festool catalogue).
We recommend the following settings on the
rotary control (2.1) for electronic machines:
5 - 6
• sanding with max. drive
• sanding old paint
4.1
• sanding wood and veneer prior to paint-
ing
• interim sanding of paint on surfaces
4 - 5
• sanding of thinly applied primer
• sanding of wood with sanding vlies
• sanding edges on wooden parts
• smoothing primed wooden surfaces.
3 - 4
• sanding full wooden and veneer edges
• sanding in the grooves/rebates of windows
and doors
• interim paint sanding on edges
• pre-sanding natural wood windows with
sanding vlies
• smoothing wood surfaces with sanding felt
5.1
prior to staining
• rubbing down stained surfaces with sand-
ing vlies
• rubbing down or removing excess lime
paste with sanding vlies
2 - 3
• interim paint sanding on stained surfaces
• cleaning natural wood window grooves with
sanding felt
1 - 2
• sanding stained edges
• sanding thermoplastic synthetics

Maintenance and care

the mains supply socket before carrying out
any work on the machine!
The cooling air vents on the motor housing
must always be free of blockages and clean
to ensure air circulation. Any maintenance
or repair work requiring the motor housing
to be opened may only be carried out by an
authorised service workshop.
5
Always remove the plug from