Attaching The Abrasive; Securing Polishing Attachments; Working With The Tool - Festool RO 125 FEQ Manual De Instrucciones

All manuals and user guides at all-guides.com
on the new sanding pad (in doing so, make
sure that the rubber collar (10.1) is cor-
rectly fi tted!),
- Let go of the spindle stop.
Actuate the spindle stop only
when the drive spindle is stationary. Do not
switch on the motor when the spindle stop
is pressed in.

Attaching the abrasive

Stickfi x is a hook-and-loop fastening
system. Stickfi x sanding pads allow
the use of self-adhesive hook-and-
loop abrasives such as Stickfi x sand-
papers and sanding cloths.
Simply press the abrasive onto the sanding
pad (7.2) and pull it off again after use.
Please note: Use only abrasives with an
undamaged Stickfi x hook-and-loop coating.
Before use, check that the coating has not
been damaged by improper use (such as
over heating).

Securing polishing attachments

To prevent damage, use PoliStick polish-
ing attachments (sponges, felt, lambswool
bonnets) only with the special polishing
pad fi tted on the tool instead of a sanding
pad. Like StickFix abrasives, the PoliStick
polishing attachments are simply pressed
onto the polishing pad and pulled off after
use.

Working with the tool

Always secure the workpiece
in such a manner that it cannot move while
being sanded.
Never overload the tool by us-
ing too much pressure! The best sanding
results are achieved when applying mod-
erate pressure. Sanding performance and
quality depend primarily on the choice of
the right abrasive.
9