Technical Data; Symbols; Operating Elements - Festool IS 330 EB Manual De Instrucciones

Insulation saw IS 330 EB
Original instruction
Table of contents
1 Technical data ......................................... 21
2 Symbols ................................................... 21
3 Operating elements ................................ 21
4 Applications ............................................. 22
5 Safety instructions .................................. 22
6 Transport and delivery ............................ 26
7 Adjustment .............................................. 26
8 Preparation for use ................................. 27
9 Operation ................................................. 28
10 Accessories ............................................. 29
11 Service and maintenance ........................ 29
12 Environment ............................................ 31
13 Fault correction ...................................... 32
1

Technical data

System voltage
Network frequency
Rated input
Movable supply
Circuit breaker
Pre-selection of number of rotations
Constant electronics
Electric safety brake
Restricted circuit power
Speed of sprocket wheel at the electronics set
at the level of:
Maximum chain speed
Mutual inclination of the guide reglet
Weight (tool included)
Depth of the cut [Guide reglet 13" (33 cm)]
at 0°
at 15°
at 30°
at 45°
at 60°
Protection class
Automatic lubrication of the guide reglet
Oil tank volume
2

Symbols

Double insulation
Warning of general danger
GB
220 - 240 V ~
50 - 60 Hz
1600 W
H07RN-F
15 - 16 A
current protection
2200 - 4600 min-1
12 m/s
0° - 60°
330 mm
315 mm
285 mm
230 mm
165 mm
~ 240 ml
Risk of electric shock
Use protective goggles!
Wear ear protection!
Wear a dust mask!
Use protective gloves!
Do not expose to rain!
Unplug the cord immediately if it is cut or
damaged
Read the instructions
Not for use on wood!
Not to be included in municipal refuse
 Advice or tip
3

Operating elements

•
•
[1-1]
Safety lock
•
[1-2]
On/off button
•
[1-3]
Guide ruler
[1-4]
Guide bar cover
[1-5]
Manual clamp screw
[1-6]
Guide runner
[1-7]
Front auxiliary handle
7 kg
[1-8]
Oil gauge
[1-9]
Oil cap
[1-10] Rotary suction adaptor
[1-11] Chain adjustment wheel
[1-12] Oil feed adjuster
[1-13] Clamping lever for reverse tilt lock
II /
[1-14] RPM selector
•
[1-15] Rear auxiliary handle
[1-16] Parallel stop
[2-1]
Chain sprocket cover
[2-2]
Fastening wheel
[2-3]
Chain
[2-4]
Guide bar
[2-5]
Hole for tension bolt
21