Thermador PROFESSIONAL PRO HARMONY PRG305PH Manual Del Usuario página 21

2. Rotate the legs using a 12'' (305 mm) adjustable
wrench on the flat sides of each foot.
3. Progression of the height adjustments should be
alternated proportionally between the four corner legs,
until the top edges of the range's side panels are close
to matching the counter top height.
4. Final height adjustments of the two rear legs take place
before moving the range into its installed position in the
cabinet.
5. As the range is moved into its final, installed position,
verify that the Anti-Tip Bracket is in a position to
engage the leg (see "STEP 4: Installing the Anti-Tip
Device" on page 12). This can be verified by viewing
through the opening near the floor.
6. With the range in the installed position, the final height
adjustments are made to the two front legs to ensure
proper alignment to the counter top.
Figure 22: Adjusting the Height of the Range
Installation Instructions
Figure 21: Leveling Legs
1/16''-1/8''
(2-3 mm)
Adjusting the Kick Panel
To adjust the kick panel do the following:
1. Remove the kick panel screws using a T-20 Torx
screwdriver.
2. Relocate kick panel at one of the five screw hole
positions, as noted below. Reinstall Torx screw.
3. Repeat with the remaining kick panel screws, assuring
kick panel is level.
• The range kick panel should maintain a minimum
½'' (12.7 mm) clearance above the floor.
Data Rating Label and Wiring Diagram
Data rating labels contain the model and serial numbers.
They can be found under the front edge of the rangetop,
with oven door open or removed.
Figure 24: Data Rating Label Location
Figure 23: Kick Panel Adjustment
English | 20 |