Safety Instructions Related To The Product And Technology - Aventics RMV04-8DI_M8 Instrucciones De Servicio

During
assembly
During commissioning
AVENTICS | PROFIBUS DP | R499050016–BDL–001–AE
2.6 Safety instructions related to the product
and technology
W
Do not place any mechanical loads on the device under
circumstances. Do not place any objects on it.
W
Ensure that the power supply is within the stipulated
tolerance for the modules.
W
Observe the safety notes found in your valve system's
operating instructions.
W
A 24 V power pack supplies all components with electricity.
The power pack must be fitted with a safe isolation in
accordance with DIN EN 60742, VDE 0551 classification.
This ensures that the electric circuits comply with SELV/
PELV electric circuits in accordance with IEC 60364-4-41.
W
Switch off the operating voltage before connecting or
disconnecting plugs.
W
The warranty only applies to the delivered configuration.
The warranty will not apply if the product is incorrectly
assembled.
W
Make sure the relevant system component is not under
pressure or voltage before assembly or disassembly.
Ensure that the system is prevented from power restoration
during assembly work.
W
Ground the modules and valve system. Observe the
following standards when installing the system:
– DIN EN 50178, classification VDE 0160
– VDE 0100
W
Installation may only be performed in a voltage-free and
pressure-free state and only by a qualified technician. In
order to avoid accidents caused by dangerous movements
of the actuators, electrical commissioning may only be
carried out in a pressure-free state.
81
For Your Safety