Aventics RMV04-8DI_M8 Instrucciones De Servicio página 82

82 AVENTICS | PROFIBUS DP | R499050016–BDL–001–AE
Applications
During operation
cleaning
W
Do not put the system into operation before it is completely
assembled as well as correctly wired and configured, and
after it has been tested.
W
The device is subject to the restrictions of the IP 65
protection class. Before commissioning, make sure that all
the connection seals and plugs are leaktight to prevent
fluids and foreign bodies from penetrating the device.
W
Make sure that there is a sufficient exchange of air or
enough cooling if your valve system has any of the following:
– Full equipment status
– Continuously loaded solenoid coils
W
During Never use solvents or strong detergents. Only clean the
device using a slightly damp cloth. Only use water and, if
necessary, a mild detergent.
3
The bus coupler is used to electrically control valves via the
PROFIBUS fieldbus system. In addition, input/output modules
allow electrical input and output signals to be output via the
valve system's bus connection.
The bus coupler is designed for use as a slave only on a
PROFIBUS DP bus system in accordance with EN 50170 Part 2.
Applications