Before Startup - Kärcher BD 43/25 C Bp Manual De Instrucciones

Ocultar thumbs Ver también para BD 43/25 C Bp:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operator console
1 OFF
Device is switched off
2 Normal mode
Wet clean the floor and vacuum up
dirt water.
3 Intense mode
Wet clean the floor and allow the
detergent to react.
4 Vacuum mode
Suck in the dirt fleet.
5 Program selection switch
6 Display
Symbols on the machine
Battery socket
Lashing point
Mop holder **
Filling level fresh wa-
ter tank 25%
Bow brush change
Vacuum bar lowering
lever
Drain outlet fresh wa-
ter tank
Dirt water discharge
hose
Transport chassis
1: Transport
0: Operation
** option

Before Startup

Unloading
 Unscrew the screws from the mid-
dle board of the pallet.
 Push down the device holding the
push handle and pull out the middle
board.
 Remove the chocks in front of and
next to the wheels.
 Push down the device holding the
push handle and push it forwards
up to the edge of the pallet.
 Lift the device off the pallet and set
it on the floor.
Install batteries
Install the batteries (see "Care and
Maintenance/Install and connect bat-
teries").
Using batteries made by other
manufacturers
We recommend using our batteries as
described in chapter "Care and Main-
tenance/Recommended batteries".
Charging battery
Note:
The device is equipped with a safety
mechanism to prevent total discharge,
i.e. when the permissible minimum ca-
pacity is reached, the brush motor and
the turbine are switched off.
 Drive the machine directly to the
charging station; avoid any steep
gradients in the process.
DANGER
Danger of injury due to electric shock.
Observe the mains voltage and fuse
protection on the type plate of the de-
vice.
Charging process
Average charging time is approx. 10 -
15 hours.
The appliance must not be used during
the charging process.
DANGER
Danger of explosion
Prior to charging low-maintenance
batteries
Remove waste water tank (see Chap-
ter "Maintenance and care/Mainte-
nance tasks/Removing the waste wa-
ter tank"). This prevents the accumula-
tion of hazardous gases underneath
the tank during the charging process.
ATTENTION
Risk of damage. Do not clean the de-
vice with water while the tank is re-
moved.
5
-
EN
1 Battery plug, appliance side
2 Battery plug, battery side
 Detach the battery plug on the unit
side.
ATTENTION
Risk of damage!
– Do not connect the charger with the
battery plug on the unit side.
– Only use a charger that is suitable
for the installed battery type:
Battery
Battery set
type
24 V
6.654-093.0 4.035-447.0 6.654-
6.654-290.0 4.035-990.0 6.654-
Note: Please read the operating in-
structions of the charger manufacturer,
especially the chapters on safety in-
structions!
 Connect the battery plug on the bat-
tery side with the charger.
 Plug the mains plug of the charger
into a power outlet.
 Execute the charging process ac-
cording to the information in the op-
erating instructions of the charger.
 Connect the battery plug on the de-
vice side with the battery plug on
the battery side.
Low maintenance batteries (wet
batteries)
WARNING
Danger of causticization!
– Adding water to the battery in its
discharged state can cause the
acid to leak.
– Use safety glasses while handling
battery acid and follow the safety in-
structions to avoid personal injury
or damage to clothes.
– Should the acid spray on to the skin
or clothes, rinse immediately with
lots of water.
ATTENTION
Risk of damage!
– Use only distilled or desalinated
water (EN 50272-T3) for filling the
battery.
Charger
329.0
332.0
7

Publicidad

Tabla de contenido
loading

Tabla de contenido