Grip Adjustment; Viewfinder Adjustment; Brightness Adjustment Of The Display; Tripod Mounting - JVC GR-D650U Manual De Instrucciones

Grip Adjustment

1
Adjust the velcro strip.
● Before making the
adjustment, remove any
security tags that may
be attached to the
velcro.
2
Pass your right hand
through the loop and
grasp the grip.
3
Adjust your thumb and
fingers through the grip to
easily operate the Recording Start/Stop Button,
Power Switch and Power Zoom Lever. Be sure
to fasten the velcro strip to your preference.
Viewfinder Adjustment
1
Set the Power Switch to "REC" while pressing
down the Lock Button located on the switch.
2
Make sure the LCD monitor is closed and
locked. Pull out the viewfinder fully and adjust it
manually for best viewability.
3
Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused.
Example:
Diopter Adjustment Control
CAUTION:
When retracting the viewfinder, take care not to
pinch your fingers.
GETTING STARTED
Brightness Adjustment Of The
Display
1
Set the Power Switch
to "REC" or "PLAY" while
pressing down the Lock
Button located on the
switch.
2
Open the LCD monitor
fully. ( pg. 19)
● To adjust the brightness of
the viewfinder, pull out the
viewfinder fully and set
"PRIORITY" to "FINDER"
( pg. 31, 33).
3
Press MENU. The
Menu Screen appears. If
you are in Playback mode,
please proceed to Step 5.
4
Press 3, 4, 2 or
1
press SET. The DISPLAY Menu appears.
5
Press 3, 4, 2 or
1
press SET. The Menu Screen closes and the
brightness control menu appears.
6
Press 3 or 4 until the appropriate brightness
is reached and press SET or 2.
7
Press MENU. The menu screen closes.

Tripod Mounting

To attach the camcorder
to a tripod, align the
direction stud and screw
to the mounting socket
and stud hole on the
camcorder. Then tighten
the screw clockwise.
● Some tripods are not
equipped with studs.
EN
3 3 3 3
1 1 1 1
4 4 4 4
MENU
BRIGHT
– 5
BRIGHT
– 5
to select "DISPLAY", and
to select "BRIGHT", and
17
2 2 2 2