Connecting The Speaker Output Terminals; Before Installing The Amplifier - Pioneer GM-A6704 Manual De Instrucciones

Connecting the units
Connecting the speaker
output terminals
1 Use wire cutters or a utility knife to
strip the end of the speaker wires to ex-
pose about 10 mm of wire and then twist
the wire.
2 Attach lugs to wire ends.
Use pliers, etc., to crimp lugs to wires.
1 Lug (sold separately)
2 Speaker wire
3 Connect the speaker wires to the
speaker output terminals.
Fix the speaker wires securely with the term-
inal screws.
1 Terminal screws
2 Speaker wires
3 Speaker output terminals
Installation

Before installing the amplifier

! To ensure proper installation, use the supplied
Twist
! Do not install in:
! Install tapping screws in such a way that the
! Make sure that wires do not get caught in the
! When drilling to install the amplifier, always
! To ensure proper heat dissipation of the ampli-
! Protection function may activate to protect the
! Place all cables away from hot places, such
En
WARNING
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier, or be-
come loose causing the amplifier to shut
down.
— Places where it could injure the driver or
passengers if the vehicle stops suddenly.
— Places where it may interfere with the dri-
ver, such as on the floor in front of the dri-
ver's seat.
screw tip does not touch any wire. This is im-
portant to prevent wires from being cut by vi-
bration of the car, which can result in fire.
sliding mechanism of the seats or touch the
legs of a person in the vehicle as short-circuit
may result.
confirm no parts are behind the panel and
protect all cables and important equipment
(e.g. fuel/brake lines, wiring) from damage.
CAUTION
fier, ensure the following during installation:
— Allow adequate space above the amplifier
for proper ventilation.
— Do not cover the amplifier with a floor mat
or carpet.
amplifier against overheating due to installa-
tion in locations where sufficient heat cannot
be dissipated, continuous use under high-vo-
lume conditions, etc. In such cases, the am-
plifier reduces the power output or shuts
down until it has cooled to a certain desig-
nated temperature.
as near the heater outlet.