Stopping The Generator - Schulz S1200MG Manual De Instrucciones

In this case, check the cause of the failure and correct it before trying to start it again.
To get out of the failure state on the controller, press the "MENU" button. After that, the controller will await
your next command.
If the start-up has worked properly, the generator will go into operation mode, and the working parameters will
be shown on the screen of the controller.
Attention!
• The "START" button only becomes active when the "ATS" function is turned off;
• The "START" button has no function when the generator is already in operation (it is a protective
measure).
• If the starting procedure presents abnormal operation, press the "STOP" button. If abnormal operation still
continues, turn the switch of the generator to the "OFF" position:
1.

STOPPING THE GENERATOR

To stop the generator, press the "STOP" button. The controller will begin the stopping process automatically,
detecting whether any error has occurred during the process:
In case of failure during the stopping process, the following screen will appear on the controller:
The above alarm cannot be canceled using the "MENU" button; you must turn off the system's power to reset.
Check the causes of the problem and correct them before using the generator again. If you have any questions,
consult a qualified electrician with knowledge of the equipment. Contact Customer Service for any additional
information.
Check the causes of the problem and correct them before using the generator again.
If you have any questions, consult a qualified electrician with knowledge of the equi-
pment. Contact Customer Service for any additional information.
STOPPING, PLEASE
ATTENTION!
STOPPING FAILED!
WAIT...
87