Alarm Functions - Schulz S1200MG Manual De Instrucciones

Where:
• "MIN" and "MAX" refer to the minimum and maximum limits, respectively;
• "ON" and "OFF" refer to the state of the selected parameter.
Use the buttons and
parameter to be configured. The selected parameter will flash.
Use the buttons and
Press the "MENU" button to return to the main options screen and follow the procedures described for each
parameter.
Press the "MENU" button again to save the changes.
Attention
• The first time the controller is powered up, all the protection parameters are set to "OFF", and it is
necessary to configure each parameter according to the needs of the application and requirements
for electrical protection (consult a qualified electrician with knowledge of the equipment in case of any
question);
• If the "MAX" value is "0", the corresponding protection will remain off;
• If the "password" is lost or forgotten, a new password can be set as follows:
- Hold down the "MENU" button for more than 3 seconds (when on the screen that asks for the password);
- The system will turn off the "start-up password protection" function;
- Set a new password on the parameter configuration screen and turn on the "start-up password protection", if
desired.
1.

ALARM FUNCTIONS

During operation of the generator, the controller monitors the status of the protection alarms according to the
parameters set. If the measured value goes outside the range permitted, above or below the configured value,
the system will enter into failure alarm mode and turn off the generator. The protection alarms are the following:
• Low oil pressure alarm;
• Low voltage alarm;
• High voltage alarm;
• Overcurrent alarm;
• Low electrical frequency alarm;
• High electrical frequency alarm;
• Low battery voltage alarm;
• High battery voltage alarm;
• High equipment temperature alarm;
• Start-up failure alarm (always enabled);
• Stopping failure alarm (always enabled).
Attention
Except for the "stopping failure alarm", all the alarms can be canceled by pressing the "MENU" button;
If an alarm occurs, be sure that the problem has been resolved before canceling the failure. For safety
reasons, use the generator only if it is in perfect conditions for use.
para selecionar o parâmetro desejado a ser configurado. to select the desired
to adjust the desired values.
89