Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING THE CONTROLLER TO Z CONTROL
Connecting with your mobile device or computer (Continued)
3. On the setup screen, press the WiFi Scan button,
scroll down to see the list of WiFi signals found, and
choose the WiFi you want the Basement Sentry
controller to use for internet connectivity. Enter
the password for the router you chose in the field
indicated. If the password is correct, the controller
will connect to the router and start sending status
updates to zcontrolcloud.com. You will see the Z
Control
LED go from blinking to solid. This could
®
take up to a minute or so.
If the LED does not turn solid, then the password
entered is incorrect, the router's security is
insufficient (see note below**), or some other
network restriction is in place (see your network
administrator). The controller will return to standby
mode if the connection to router is not successful. If
you need to force the controller into AP mode again,
press the Z Control
Figure 1). This will cause the controller to re-enter
AP mode and begin transmitting the SSID again.
Repeat Steps 2 and 3.
4. Once the controller LED is solid, log in to your
account (or create one) at zcontrolcloud.com.
** The controller will not connect to routers with 'WEP'
or 'OPEN' security.
button for 12 seconds (See
®
© 2020. All rights reserved.
®
3
Click WiFi
Scan button
4
Click WiFi
Scan
button
Available
WiFi will
show here.
Choose the
one you
want.
** The controller will not connect to
routers with 'WEP' or 'OPEN' security.
15
Publicidad
