Publicidad
Idiomas disponibles
Idiomas disponibles
BASEMENT SENTRY CONTROLLER FUNCTIONS
There are two buttons on the front of the controller.
1. Silence/Reset - Can be pressed to silence current
alarms for 24 hours.
Can be held for 3+ seconds to reset (or clear) alarms
and LEDs. Flashing LEDs for conditions such as bad/
disconnected battery or power outage, for example,
can't be cleared by Silence/Reset. These conditions
must be resolved to eliminate the LED indicator.
2. Test - Will run the pump to determine if amp draw of
pump is within range.
Controller is factory programmed to self-test the pump
for several seconds every 7 days. This schedule may
be modified once the controller is connected to the Z
Control Cloud.
Pressing the test button will start the 7 day timer for
self-testing.
Test and Silence/Reset -
Holding both buttons together for about six seconds
will initiate a factory reset. This returns the firmware's
device configuration to the state in which it left the
factory. Any over-the-air firmware updates that have
been installed will be retained.
BASEMENT SENTRY LED LIGHT FUNCTIONS
AC
AC
AC
FLOAT
POWER
POWER
POWER
STATUS
BATTERY
BATTERY
BATTERY
PUMP
AC
AC
PUMP
PUMP
9
© 2020. All rights reserved.
1
P L A T I N U M
AC
POWER
24/7 BASEMENT
PROTECTION
BATTERY
USB
1-800-584-8089
BasementSentry.com
RESET
FLOAT
2
P L A T I N U M
POWER
24/7 BASEMENT
PROTECTION
BATTERY
USB
1-800-584-8089
BasementSentry.com
RESET
FLOAT
AC
FLOAT
POWER
STATUS
DC
DC
BATTERY
PUMP
by
FLOAT
STATUS
TEST
DC
Silence/
PUMP
Reset
SILENCE
DC
FUSE
PUMP
30 AMP
by
AC
FLOAT
STATUS
TEST
DC
PUMP
SILENCE
DC
FUSE
PUMP
30 AMP
Test
Publicidad
