Black and Decker BXAC9001E Traducción De Instrucciones Originales página 9

exhaust pipe assembly shall be removed; otherwise it
will lead to not obvious dehumidification effect or display
"FL" water full alarm.
Compressor protection:
♦ Three minutes later after power on / restart, compressor
starts to run.
Water tank full protection:
♦ When the water level in the bottom water plate is above
the warning level, the unit will alert automatically a.
♦ Please discharge water in the machine according to
chapter "water drainage".
Water drainage:
♦ When the inner water tank is full, its indicator will flash
on the screen.
♦ The appliance enters into standby mode.
♦ Pull out the plug to drain out water, power off the machi-
ne and restart it , the machine will runs normally .
♦ This model have self evaporative function, under cooling
mode, please do not use continue drainage to get better
cooling effect.
♦ Once you have finished using the appliance:
♦ Turn the appliance off, using the on/off switch.
♦ Unplug the appliance from the mains.
Once the appliance has been used:
♦ Stop the appliance by pressing button (A) on/off
♦ Unplug the appliance from the mains.
♦ Unplug the appliance from the mains and allow it to cool
down before starting any cleaning operation.
♦ Clean the electrical assembly and the mains plug with a
damp cloth and dry them afterwards. NEVER SUBMIT
THEM IN WATER OR ANY OTHER LIQUID.
CLEANING
♦ Wipe the appliance with a damp cloth impregnated with
a few drops of detergent. Do not use solvents or prod-
ucts with an acidic or basic pH factor such as bleach or
(Original instructions)
abrasive products to clean the apparatus.
♦ Do not immerse the connector in water or other liquid or
place it under the tap. If the appliance is not maintained
in good condition.
♦ Cleaning, its surface can be degraded and inexorably
affect the life of the appliance and lead to a dangerous
situation.
Cleaning the air filter:
♦ Clean the air filters every 2 weeks. If the air filter is
blocked with dust, its effectiveness will be reduced.
♦ Washing the air filters by submerging them
♦ Carefully in warm water with a neutral detergent, rinse
them off and let them dry completely in a shady place.
♦ Install the filters carefully after having them cleaned.
After Periodic Maintenance:
♦ Switch off the appliance and remove the plug.
♦ Separate the exhaust pipe from the air and store it
carefully.
♦ Put the appliance in a dry place.
♦ Remove the batteries from the remote control and store
them carefully.
ANOMALIES AND REPAIR
♦ In the event of a fault, take the appliance to an autho-
rized service center. Do not attempt to disassemble or
repair it as there may be danger.
♦ Any person who is involved with working on or breaking
into a refrigerant circuit should hold a current valid certif-
icate from an industryaccredited assessment authority,
which authorizes their competence to handle refriger-
ants safely in accordance with an industry recognized
assessment specification.
♦ Servicing shall only be performed as recommended by
the equipment manufacturer. Maintenance and repair
requiring the assistance of other skilled personnel shall
be carried out under the supervision of the person
competent in the use of flammable refrigerants.
♦ If any fault is detected, refer to the following table:
ENGLISH
9