Electrical System Carried Out By The Factory - Riello RS5F Instrucciones De Instalación, Uso Y Mantenimiento

5.10.1 Electrical system carried out by the factory

Main
switch
230V
Key
C Capacitor
CN1 Probe connector
E Electrode
h.. Hour counter
MV Motor
PA Minimum air pressure switch.
PG Minimum gas pressure switch
RS Remote reset
SO Ionisation probe
S3 Lockout signal (230V - 0.5A max.)
T6A Fuse
TB Burner earth
TL Limit thermostat
TS Safety thermostat
V10 Safety valve
V11 Adjustment valve
X.. Plug
XP.. Socket
~ 50 Hz
Installation
D4626
 Do not invert the neutral with the phase in the
 Check that the electrical supply of the burner
ATTENTION
 The section of the conductors must be at
Check the
thermostats and check it locks out by opening the
connector (CN1)(Fig. 16) inserted in the probe's
red wire, located on the outside of the control box.
ATTENTION
If the cover is still on, remove it and proceed with
the electric wiring following the wiring diagrams.
Use flexible cables in compliance with EN 60 335-
CAUTION
1 standards.
21
GB
CARRIED OUT
AT THE FACTORY
THE INSTALLER
electrical supply line.
corresponds to that
identification label and in this manual.
2
least 1mm . (Unless requested otherwise by
local standards and legislation).
burner stops by opening
BY
Fig. 16
shown on the
the
20141167