Bremont AC-TI-GMT Manual Del Usuario página 4

CHANGING THE STRAp
RemovIng a stRap
Use the end of your watch tool to
carefully lever the spring bar out
of the lug.
FIttIng a stRap
Place one end of the spring bar
into the hole in the lug and use the
end of the watch tool to lever the
other end into position.
BREMONT AC-TI-GMT
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. The mechanical movement with automatic winding has a
free-swinging rotor that keeps the mainspring wound via the motion of
your wrist. The movement in your BREMONT AC-TI-GMT has 21 jewels,
runs at 28,800 bph and has a 42-hour power reserve once fully wound. The
watch is water resistant to 500m (50ATM) and the dial is protected by a
dual anti-reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
WINdING THE WATCH
Your watch has a screw-in crown. The purpose of the screw-in crown is
to protect the watch from penetrating water and to avoid unintentional
adjustment of the time or date. To unscrew the crown, rotate the crown
to the left where it will automatically assume position I. This position
is also the winding position for the watch, and you can manually wind
the watch by hand. The movement will automatically start with just a
few revolutions of the rotor, however it is better to wind the movement
fully with 30-40 revolutions of the crown. By doing this you will achieve