Adjustment Of Cutting Width - Sears Kenmore 385.16655100 Manual De Instrucciones

Adjustment of cutting width
When cutting width is too narrow or too wide for seam
width, adjust as follows.
Turn off the power switch and unplug the machine.
Open the looper and side covers.
Turn the cutting width adjusting dial to get desired
position of lower knife.
(A) When cutting width is too narrow:
Turn cutting width adjusting dial clockwise.
Lower knife will move to right.
(B) When cutting width is too wide:
Turn the cutting width adjusting dial
counterclockwise.
Lower knife will move to left.
Close the looper and side covers.
Test stitch to check the cutting width.
• The cutting width of the model can be adjusted
approximately 1/8" to 3/16" (3.0 to 5.0 mm) from the
right needle position depending upon your sewing needs
or fabric being used.
(A)
Standard
Est_ndar
Standard
1=1_3
h%]
(B)
i
i
i
I
! !
!
al
2O