GRAPHITE 58G941 Manual De Instrucciones página 23

14. Ignition switch
15. Fuel filler plug
16. Carburettor adjustment screws, L and H
17. Low speed adjustment screw T
18. Oil filler plug
19. Bumper spike
20. Guide bar
21. Chain
22. Guide bar chain wheel
23. Shoulder strap
24. Shoulder strap spring hook
25. Shoulder strap holder
26. Membrane pump
27. Protection nut
* Differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Guide bar cover
2. Guide bar
3. Chain
4. Key for ignition plugs
5. Screwdriver for carburettor adjustment – 1 pce
6. Shoulder strap
7. Steel file
8. Use petrol-oil blend tank
CARRYING THE CHAIN SAW
Prior to carrying the chain saw slide chain cover onto guide bar and chain. When carrying the chain
saw, hold it by front handle. Do not carry the saw when holding main handle. If several cuttings are
to be made, switch off the chain saw with the ignition switch between consecutive tasks.
INSTALLATION OF GUIDE BAR AND SAW CHAIN
Use pin and adjustment screw for adjustment of chain tension. It is very important that the bolt
located on adjustment screw falls into hole in the guide bar during installation of the guide bar.
You can move the bolt to the front and back by turning the adjustment screw. Those parts must be
set appropriately prior to starting guide bar installation in the saw.
Guide bar and chain are supplied separately.
●
Brake lever ( 6) must be in the upper (vertical) position (fig. A).
●
Unscrew the guide bar fixing nuts (
●
Put the chain ( 21) onto driving chain wheel located behind the clutch.
●
Install the guide bar ( 20) (slide it behind the clutch) onto guiding screws (c) and push towards driving
chain wheel (fig. B).
●
Put the chain ( 21) onto guide bar chain wheel (22) from below.
– 1 pce
– 1 pce
– 1 pce
– 1 pce
– 1 pce
- 1 pce
- 1 pce
PREPARATION FOR OPERATION
7) (27) and remove the casing (10).
23