Imetec TITANOX K109 Manual De Instrucciones página 14

EN
• The electrical safety of this appliance is only guaranteed when it
is connected correctly to an effective earthing system as required
by applicable electrical safety standards. This important safety
requirement must be verified and, if in doubt, request a thorough
check of the system by a qualified technician.
DO NOT immerse the iron, the power cord or the plug in any kind
of liquid.
DO NOT leave the hot iron in contact with easily flammable fabric.
DO NOT leave the iron unattended when connected to the power
supply.
DO NOT dispense steam when the iron is resting on its mat.
ATTENTION! Hot surface.
DO NOT use chemical additives, scented substances or
descaling agents.
• This iron is not equipped with a pressure boiler and has been
designed to be used for brief periods of time in order to prevent
stress related to this chore. For this reason it is recommended not
to iron for more than an hour.
IMPORTANT GUIDELINES
The appliance is designed to work with tap water; however, if the
water in your area is very hard, mix the tap water (50%) with distilled
and/or demineralised water (50%). Salt concentration in water in
certain seaside areas is very high: in such cases it is important to use
"demineralised water for irons" available on the market. If in doubt,
only demineralised water for steam irons must be used.
Do not use diluting agents, scented liquids or descaling agents as
these substances can damage the product. Do not use water from
dryers, air-conditioners and rain water.
The reservoir may contain some water as each product is tested before
being put on the market.
It is recommended to place a cloth between the iron and the fabric
when using the iron for the first time.
It is recommended to direct a jet of steam into the air before starting
12