After Ironing; Maintenance - Imetec TITANOX K109 Manual De Instrucciones

Warning: the plate temperature LED (1) goes on intermittently while ironing,
thereby indicating that the selected temperature is maintained.
SUPER-STEAM AND VERTICAL STEAM
Press the super-steam button (4) to generate a strong shot of steam that penetrates the
fabric and eliminates the most difficult creases.
Wait a few seconds between each pressing action of the iron [Fig. E].
Press the super-steam button (4) intermittently to iron in an upright direction (curtains, hung
clothes, etc.) [Fig. F].
Warning: the super-steam function can only be used at high temperatures.
Stop the steam when the plate temperature LED (1) lights up and start
ironing when this goes off.
SPRAy FUNCTION
Verify that there is water in the reservoir (11).
Press the spray button (3): slowly for dense spray or fast for mist [Fig. G].
Warnings: dampen delicate fabric using the spray function (3) or
alternatively, lay a damp cloth between the fabric and the iron.
Do not use the spray on silk or synthetics.
EMPTyING PROCESS
Disconnect the plug (13) from the socket.
Open the latch (6)
Empty the reservoir (11) by turning the iron upside down and shaking it lightly.
Let the iron cool down completely.
Always set the iron upright.
SELF CLEAN/CALC-CLEAN SySTEM
The function allows the internal part of the plate to be cleaned from limescale residue or
other impurities.
It is recommended to implement this function every 5 - 10 times it is used.
Fill the water reservoir (11) up to the maximum (MAX) level (9).
Set the steam selector (5) to 0.
Adjust the temperature knob (2) to maximum and wait for the plate temperature control LED
(1) to go off.
Disconnect the plug (13) from the socket and immediately place the iron in a horizontal
position over a wash basin.
Press the Calc-Clean (8) button until hot water, steam and any impurities or limescale come
out of the plate.
Once the iron plate has cooled down (10), clean it with a damp cloth.

AFTER IRONING

MAINTENANCE

EN
15