Communication Protocol; List Of Commands - RADWAG R Balances Serie Manual Del Usuario

15. COMMUNICATION PROTOCOL

General information
A. A character based communication protocol balance-terminal is designed for establishing
communication between a RADWAG balance and a peripheral device via RS-232C serial
interface.
B. It consists of commands sent from a peripheral device to the balance and responses from
the balance.
C. Responses are sent from the balance on each receipt of a command as a reaction to a
specific command.
D. Commands, forming the communication protocol, enable both, obtaining data on balance
status and influencing balance operation, e.g.: acquiring measurement results from the
balance, zeroing, etc.

15.1. LIST OF COMMANDS

Command
Z
T
OT
UT
S
SI
SU
SUI
C1
C0
CU1
CU0
DH
UH
ODH
OUH
SM
TV
RM
NB
SS
IC
IC1
IC0
K1
K0
OMI
OMS
OMG
UI
US
UG
BP
Command overview
Zero balance
Tare balance
Give tare value
Set tare
Send stable measurement result in basic measuring unit
Immediately send measurement result in basic measuring unit
Send stable measurement result in current measuring unit
Immediately send measurement result in current measuring unit
Switch on continuous transmission in basic measuring unit
Switch off continuous transmission in basic measuring unit
Switch on continuous transmission in current measuring unit
Switch off continuous transmission in current measuring unit
Set min checkweighing threshold
Set max checkweighing threshold
Give value of min checkweighing threshold
Give value of max checkweighing threshold
Set mass value of a single item
Set target mass value
Set reference mass value
Give balance serial number
Value release
Internal adjustment performance
Disable automatic internal adjustment of the balance
Enable automatic internal adjustment of the balance
Lock balance keypad
Unlock balance keypad
Give available working modes
Set working mode
Give current working mode
Give accessible units
Set unit
Give current unit
Activate sound signal
- 85 -